Select the correct board Tools>Board>Node MCU 1.0 (ESP-12E Module).To upload the code you need to select the following settings: This will blink the Red LED on the Node MCU board. You should test the IDE using the Blink example. Then follow the instructions here to add the ESP8266 board to the Arduino IDE. These boards are convenient because they can be connected directly to your computer for progamming and serial console.įirst install the Silicon Labs CP2102 USB to UART Bridge driver for your operating system. This assumes that yo have a NodeMCU type board with the Silicon Labs CP2102 USB to UART Bridge. A guide to getting started with the ESP8266 with the Arduino IDE
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |